AS VC Filter

Voltage Controlled Filter

Filter


2.1.0

AS Drums n Filters website

User manual

Author: Alfredo Santamaria

Author email:

Changelog

License: See EULA

Last updated:

Created:

Plugin: AS Drums n Filters

Browse all modules from AS


VC Filter is a resonant filter with a low pass and a high pass mode. Use it to darken or thin out a sound, add a resonant peak, or sweep the tone with an LFO or an envelope.

  • FREQ: the cutoff, from 40 Hz to 12 kHz. In low pass mode, frequencies above it are cut; in high pass mode, frequencies below it are cut.
  • RES: resonance. Turn it up to boost the frequencies around the cutoff for a sharper, more vocal sound.
  • MIX: balance between the dry and the filtered signal. Fully right (the default) you hear only the filter.
  • LP / HP switch: low pass (removes highs) or high pass (removes lows). Switching between low pass and high pass is smooth, so there’s no click.
Inputs and outputs

FREQ, RES and MIX each have a CV input on the left, next to their knob. Each voltage adds to its knob.

  • FREQ follows about 1V/octave: +1V doubles the cutoff.
  • RES and MIX: 10V covers the whole range.

The CV input next to the LP/HP switch flips the mode on each trigger.

IN and OUT are the audio input and output. The module is polyphonic: it filters up to 16 channels, and the FREQ, RES and MIX CVs can be polyphonic too.

When you bypass the module in Rack, the input goes straight to the output.

Starter tips

For a classic synth sweep, use low pass, turn RES up halfway and patch an envelope into the FREQ CV input.

On a drum loop, use high pass and slowly raise FREQ to build tension before a drop.

Patch a clock or a sequencer gate into the LP/HP CV input to jump between dark and thin sounds in time with the music.

Set MIX around the middle to keep some of the original sound under the filter.