Voltage Controlled Stereo Filter
2.1.0
Author: Alfredo Santamaria
License: See EULA
Last updated:
Created:
Plugin: AS Drums n Filters
VC Filter Stereo is a stereo resonant filter with a low pass and a high pass mode. Both channels share the same controls, so the stereo image stays intact while you shape the tone.
- FREQ: the cutoff, from 40 Hz to 12 kHz. In low pass mode, frequencies above it are cut; in high pass mode, frequencies below it are cut.
- RES: resonance. Turn it up to boost the frequencies around the cutoff for a sharper, more vocal sound.
- MIX: balance between the dry and the filtered signal. Fully right (the default) you hear only the filter.
- LP / HP switch: low pass (removes highs) or high pass (removes lows). Switching between low pass and high pass is smooth, so there’s no click.
Inputs and outputs
FREQ, RES and MIX each have a CV input on the left, next to their knob. Each voltage adds to its knob.
- FREQ follows about 1V/octave: +1V doubles the cutoff.
- RES and MIX: 10V covers the whole range.
The CV input next to the LP/HP switch flips the mode on each trigger.
The L and R inputs (marked I) take your signal. With only L connected, the same signal goes to both sides. The L and R outputs (marked O) are the stereo output.
The module is polyphonic: it filters up to 16 channels on each side, and the FREQ, RES and MIX CVs can be polyphonic too. A mono cable into an input is used for every channel.
When you bypass the module in Rack, the inputs go straight to the outputs.
Starter tips
For a classic synth sweep, use low pass, turn RES up halfway and patch an envelope into the FREQ CV input.
Put it at the end of a stereo mix and slowly raise FREQ in high pass mode to build tension before a drop.
Patch a clock or a sequencer gate into the LP/HP CV input to jump between dark and thin sounds in time with the music.
Set MIX around the middle to keep some of the original sound under the filter.
